When something stops working in your home or building, the first question is usually the same: is this a quick fix or something bigger. A dead outlet, a breaker that keeps tripping, a light fixture that flickers for no clear reason. These are the calls we handle, and getting a straight answer starts with a phone call. We handle the full range of residential and commercial electrical work in Orange Township and the surrounding Delaware County area, and the rate is confirmed before anything is scheduled.
Orange Township has a mix of newer construction and established neighborhoods, and the electrical work that comes out of a place this size covers a wide range. Homeowners dealing with panel capacity questions before adding an EV charger, businesses needing a dedicated circuit for new equipment, property managers keeping rental units up to code. We take all of it.
Call (380) 289-2878 and describe what you need.
Some electrical faults are straightforward. A breaker trips, you reset it, you figure out what overloaded the circuit, and the job is done. Others are harder to pin down, and those are the ones worth calling about sooner rather than later.
A circuit that fails only under load, an outlet that works most of the time but not always, a breaker that trips on a Tuesday and runs fine for three weeks before doing it again. These intermittent faults are not random. There is a cause behind every one of them, and finding it is a diagnostic job in its own right. The fault might be a loose connection that only opens under heat. It might be a breaker that is wearing out but has not failed completely. It might be a wiring fault that only shows up when the circuit is carrying a full load.
We trace the fault before any work begins. That means testing, not guessing. The explanation comes before the repair, and the rate for the fix is confirmed before we start.
A circuit that trips when it rains, or only when a specific appliance is running, or only after the house has been closed up for a few hours, is telling you something about where the fault is. Moisture intrusion at an outdoor junction box, a shared neutral that is losing its connection, a GFCI outlet upstream that is failing and taking a whole run of receptacles with it. These are not difficult to fix once they are found. Finding them is the work.
AFCI and GFCI protection failures can look like ordinary electrical problems until the underlying cause is traced. A tripping AFCI breaker on a bedroom circuit might be a nuisance trip from a device that produces electrical noise, or it might be a real arc-fault condition in the wiring that warrants attention. We check both before we call it one or the other.
Grounding and bonding issues are common in older homes and are easy to overlook because they often produce no obvious symptom until something goes wrong. A mild tingle from a faucet, a reading on a voltage tester at an outlet that should show none, a panel that has never been properly bonded to the grounding electrode system. These are not cosmetic. We check grounding as part of any diagnostic visit and address what we find.
Lighting is one of the most common calls we get, and it covers more than replacing a fixture. A room that has always felt dim, a kitchen where the overhead light is in the wrong place, a garage with one bare bulb on a pull chain, a front entry with no exterior light at all. These are fixable, and the fix is usually straightforward when it is planned correctly.
Indoor lighting work includes recessed lighting installation, ceiling fan wiring and installation, under-cabinet lighting in kitchens, and fixture replacement of all kinds. When a room has no existing wiring for a ceiling fixture or a fan, we run the circuit. Where a dimmer switch is the right answer, we wire it correctly for the fixture type so it does not buzz or flicker.
Outdoors, security lighting and motion sensor lights are among the more practical upgrades a homeowner can make. A well-lit driveway and entry point does real work. Weatherproof outlets for a garage or a covered patio, landscape lighting along a walkway, a detached structure that needs its own circuit. We run the wiring, mount the fixtures, and confirm everything is sealed and grounded for outdoor exposure. When other electrical work is already scheduled, adding a lighting circuit at the same time is often the most efficient way to get it done.
Scheduling a service call is simple, and getting a rate before you commit to anything is part of how we work.
Call (380) 289-2878, describe the job, and the person on the phone will scope it with you.
Most common jobs can be priced accurately from a description. The rate is confirmed before the visit is booked.
What moves a quote from one range to another is usually one of three things. The first is what the fault actually turns out to be once it is traced, because a loose connection at an outlet and a wiring fault behind the wall are different jobs. The second is what has to be opened up to reach it, because wiring behind plaster or in a finished ceiling takes more time than work in an open basement. The third is whether the existing circuit or panel can carry the change being requested.
An older panel is worth a look before a big appliance goes in. A 100-amp service that was adequate for the home as originally built may not have room for an EV charger, a new HVAC circuit, and a kitchen renovation without a panel upgrade first. We check capacity before running a new circuit, and if the panel needs attention, that conversation happens before any work starts.
We are available every day from 6:30 AM to 9:00 PM. That covers most schedules without requiring anyone to take a full day off or wait until the weekend.
Call (380) 289-2878 during those hours, describe the situation, and we will tell you what the current schedule allows.
Some electrical problems are worth watching. Others are not. A burning smell near a panel, an outlet that sparks when you plug something in, a breaker that will not stay reset on a circuit you need running. These are calls worth making right away. We take short-notice work when the schedule allows, and the sooner you call, the sooner someone is out.
Commercial calls in Orange Township often have a timing constraint. A business that needs to stay open, a tenant who cannot be without power for a full afternoon, a property that needs the work done before a new lease starts. We work through those constraints on the call. The scope and the schedule are both confirmed before the visit is booked, so there are no open questions going into the job. The wider scope of the work is on our electrical repair services page.
A room with no ceiling fixture, a kitchen that needs recessed lighting in place of a single overhead, a bathroom where the exhaust fan and the light are on the same switch and should not be. These are the situations that lead to a lighting call. We run the circuit where there is none, replace what is there, and wire switches and dimmers correctly for the fixture load.
A Level 2 home charger runs on a dedicated 240-volt circuit pulled from the main panel to the garage. We confirm panel capacity before the circuit is run. If the panel does not have room, that conversation comes first. The charger is wired and the circuit is sized for the unit going in, not just for what the panel happens to have available.
Homes in Delaware County with knob-and-tube wiring or aluminum branch-circuit wiring present specific challenges. Knob-and-tube has no ground conductor and was not designed for modern electrical loads. Aluminum branch wiring requires careful attention at every connection point to stay safe. Rewiring replaces the old conductors with copper, run correctly through the home. Some homes need a full replacement. Others need targeted work in specific rooms or circuits. We assess what is there and explain the scope before any work starts.
GFCI outlets in kitchens, bathrooms, garages, and outdoor locations. AFCI breakers on bedroom and living-area circuits. USB outlets where a homeowner wants a built-in charging point. Standard outlet and switch replacements throughout a home or commercial space. These are straightforward jobs that often get combined with other work already on the schedule.
Homes built in certain periods used aluminum for branch-circuit wiring, and the connections that aluminum wiring makes at outlets, switches, and fixtures behave differently than copper over time. The connections can loosen and create heat at the point of contact. Remediation addresses each connection point with the correct method, either replacing the device with one rated for aluminum or using an approved connector to terminate the aluminum safely. We identify aluminum wiring during any inspection or diagnostic visit and explain the options.
We cover Orange Township and the surrounding area throughout Delaware County. That includes Perry Township, Powell, Liberty Township, Berlin Township, and Genoa Township. Residential and commercial calls from all of these communities are welcome. The same availability, the same process, and the same rate-before-you-book approach applies regardless of which town the call is coming from.
You schedule it. We power it. Simple as that.
A partial power loss where half the property is dark and the other half is fine usually points to a lost leg at the service entrance. The panel receives two 120-volt legs from the utility, and if one fails, every circuit on that leg goes down. This is often a utility issue, but we diagnose from the panel in to confirm where the fault lies.
Yes. We handle residential and commercial electrical work throughout the area, including Powell, Perry Township, Liberty Township, Berlin Township, and Genoa Township.
The same process applies: call (380) 289-2878, describe the job, and we confirm the rate before anything is booked.
Rough-in is the first phase of electrical work in a new build or renovation: running the wiring, installing boxes, and getting everything in place before the walls are closed. Trim-out is the second phase, done after drywall, when outlets, switches, fixtures, and covers are installed and the circuits are energized and tested.
A tenant can call us to describe the problem, and we can scope the issue on that call. Scheduling and payment are typically arranged with the property owner or manager, so we confirm who is authorizing the work before we book the visit.
Stop using the outlet or circuit immediately and call us. A burning smell near an outlet or panel is a sign of heat at a connection point, which can indicate a wiring fault, a failing breaker, or an overloaded circuit. It is not a problem to watch and wait on.
We are available every day from 6:30 AM to 9:00 PM at (380) 289-2878.
A transfer switch is the answer. It physically disconnects the property from the utility line before the generator circuit is energized, which prevents power from flowing back into the grid. We install the transfer switch as part of every generator hookup, and we do not connect a generator without one.
Older properties often have a mix of wiring methods from different eras, and each type has its own characteristics and requirements. We identify what is present, explain what each section involves, and flag anything that needs attention before we add to or modify any part of the system.
Homes built before the 1980s in Delaware County often have wiring or panel configurations that were not designed for today's electrical load. Knob-and-tube wiring, aluminum branch circuits, and original 100-amp panels are all common in established neighborhoods. If your home has any of these, a call to scope the situation is worth making before adding a major appliance or a new circuit.
Yes. Property managers and landlords with multiple units can call us to discuss how to handle scheduling across properties. We confirm the scope and the rate for each job individually, and we work with the contact you designate for each property.
Call (380) 289-2878 for a quote on any electrical job in Orange Township or the surrounding Delaware County area.
We are available every day from 6:30 AM to 9:00 PM. Describe what is happening and we will scope the job and confirm the rate on the call. The sooner you call, the sooner someone is out to take a look. We handle the full range of residential and commercial electrical work, and the first step is a phone call.
Wiring and panel work nearby: Westerville, Upper Arlington, Gahanna, Jefferson Township.
Everywhere else we go is in our coverage area list.
Most electrical problems in Orange Township, Delaware County show up as a symptom first: a breaker that won't stay reset, an outlet that stopped working, lights that flicker when the heat kicks on. The table below maps out the work we handle, who each service fits best, and what is practical to know before you call. If you have questions about a specific job, the rate and the scope are both confirmed on the phone before anything is scheduled.
| Service | What the Job Involves | When You Need It | Good to Know |
|---|---|---|---|
| Backup Generator Installation |
| Homeowners who need reliable power through Ohio ice storms and wind events | The transfer switch isolates the home from the utility line so the generator runs safely without back-feeding the grid. It is required for a legal hookup. |
| Electrical Panel & Service Upgrades |
| Homes with a 100-amp panel, frequent tripping, or plans to add an EV charger or major appliance | A panel sized for a 1970s home was not designed for today's electrical load. A service upgrade removes the capacity constraint and gives the home room to grow. |
| Wiring for Additions & Remodels |
| Homeowners adding a room, converting a garage, or building a home office | Electrical planning at the start of a remodel avoids the cost of opening finished walls later. We scope the load before the first wire is pulled. |
Call (380) 289-2878 to describe your job, get the rate, and find out what the schedule allows.
(380) 289-2878